tpl_sitevar1528 Inloggen | Registreren | Zoeken
 
RAG

Informatie

LAN parties

Scene

Links

Nieuws

Casemodding

 		 
2005 - Castle Mod  
Gemod door [RAG]Bitchie gepost op Woensdag 21-06-2005 Bron: RAG

Same bricks as case 8, this time I made a very light aluminium sleeve which falls over my Shuttle case SB77G5. Then used the plaster bricks to cover the aluminium and at the front I made a large wooden door-bridge. Made aluminum hinges and stainless steel chains to hold it. Because I made the connector for the Harddrive LED the same, i can use the same dragon as in case 8.
-> Meer...

 

 

 

 ->

2005 - Dragons Lair (Castle Epia)  
Gemod door [RAG]Bitchie gepost op Woensdag 21-06-2005 Bron: RAG
Made this case from molding plaster bricks and glueing them together into a small castle. This case holds a Via Epia Nano ITX mainboard, which is the smallest board i've seen so far. The harddrive high-power laser LED is extended and comes out the dragon's mouth. A small coolermaster fan is cooling the board and uses the staircase as a chimney.
-> Meer...		 ->

2004 - Stealthtower  
Gemod door [RAG]Bitchie gepost op Woensdag 5-1-2005 Bron: RAG
This is actually the Black-Tower, but redisigned in a new mod; where in the Black Tower, you could see all the parts, this Steel Tower shows nothing. zilch. nada.  No stealthed drives, no power switches or even a LED. Top, front and sidepanel from 1,5 mm Stainless steel. Power supply modded to the front of the case, DVD rom modded to the back, switches and leds all to the back.Inlet and out lets also to the back. Yes, a CPU air duct is in place :)
-> Meer...		 ->

2004 - Blacktower  
Gemod door [RAG]Bitchie gepost op Woensdag 5-1-2005 Bron: RAG
Black-Tower
Made from old scrap parts and leftovers. Cut away as much as possible from an existing case and replaced the top, front and side with 4 mm plexiglas.
-> Meer...		 ->

2003 - Koffer 3 - Plexie Koffer  
Gemod door [RAG]Bitchie gepost op Woensdag 5-1-2005 Bron: RAG
Made from 8 mm plexiglass, i manufactered a suitcase large enough for all components, and still have breathing space. My little mascotte is a action figure from Quake and in her BFG I mounted the harddrive LED. Keyswitch ofc. I modded the Taisol heatpipe cooler and made a virtual airduct which worked very well.
-> Meer...		 ->

2002 - Koffer 2 - Gamma Koffer  
Gemod door [RAG]Bitchie gepost op Woensdag 5-1-2005 Bron: RAG
Cheap-ass suitcase mod. Replaced half of suitcase with plexiglass panels and ofc a CPU air duct on a Taisol heatpipe cooler. Key switch.
-> Meer...		 ->

2001 - Cube  
Gemod door [RAG]Bitchie gepost op Woensdag 5-1-2005 Bron: RAG
Total new design, half a case of 10 mm plexiglas, other half of 3 mm hard-aluminium. You'll notice the infamous air duct again ? Stealthed DVD drive, Key switch. Lots of space in the cube, but soooo heavy. Not my best LAN case.
-> Meer...		 ->

2001 - Koffer 1 - Piloten Koffer  
Gemod door [RAG]Bitchie gepost op Woensdag 5-1-2005 Bron: RAG
Going to LANparties was becoming a lifestyle, so my case needed to be easy to drag along. I wanted a slightly different suitcase mod as the rest allready has been done before. So I came up with a pilot-case, where the lid comes open from the top in two parts. Had to build the power-supply in without its case, or it wouldnt fit. CPU air duct used again :-) Power on by key switch.
-> Meer...		 ->

2001 - RAG Case  
Gemod door [RAG]Bitchie gepost op Woensdag 5-1-2005 Bron: RAG
My first mod, this was the first time I came to the idea of letting the CPU get fresh cool air for cooling, instead of letting the air first warm up when it passes all other heat components. I constructed a duct which sucked the fresh cool air from the front of the case and with a adapter mounted it to the Dragon Orb Cooler. A 12 cm ultra-low-noise papst was mounted on top to help get the heated air out. The clan name RAG was dremeled out of the sidepanel.
-> Meer...		 ->